Arb 3438320 Bedienungsanleitung PDF herunterladen (Seite 14)

Last Rev Date: 17/11/2009 Page 14 of 18 Fitting instructions# 3787059

BULL BAR FITMENT TO VEHICLE

53. Ensure the bull is sitting on the vehicle level

and the gap between the bumper bar and the

bull bar wing is parallel.

54. If the bar is not centred on the vehicle, tap the

mount brackets sideways with a soft hammer

until the bar is central

55. Once happy with the position of the bull bar

and the clearance gap is between 15mm – 18

mm tighten all the mount bolts to specified

torque

56. The stone shield cross brace can now be

fitted to the flange attached to the impact

absorber using an M8 bolt, spring washer, flat

washer and M8 flange nut set per side.

57. Tighten both sides.

58. Install the two M6 cage nuts (long leg) with

the body of the nut facing upward.

59. Using an electric drill and a 10.0 mm drill bit,

drill two pinning bolt holes through the bull

bar upright each side using the holes in the

mount bracket flanges as a guide. One hole

is located in the lower lug of the mount face

and one up above the welded nuts. Use

access through the light surround opening for

the top hole.

15 / 18 mm (5/8”) GAP

REQUIRED

Flanges face

forward

Warning: Drilling operations can result in flying

metal debris, safety glasses should be worn.

1 2 ... 9 10 11 12 13 14 15 16 17 18

Keine Kommentare

Arb 3438320 Bedienungsanleitung Seite 14