13/06/06 Page 1 of 13 3782863 If you have any queries regarding the installation of this product please contact the distributor from whom it was purc
13/06/06 Page 10 of 13 3782863 21. (If not fitting winch) 1. Wrap rubber extrusion around winch cover. 2. Place washers over the winch cover fixin
13/06/06 Page 11 of 13 3782863 24. 1. With the aid of another person place the bar on the mounts. Line the bar to the vehicle and fasten using six
13/06/06 Page 12 of 13 3782863 27. 1. Place the rubber caps over the cut ends of the wires. 28. 1. Next step is to lock pin the bar so there is n
13/06/06 Page 13 of 13 3782863 30. 1. There are two dia 16 hole located on the top face of the bar. If no CB arials are fitted the holes can be cov
13/06/06 Page 2 of 13 3782863 USE PART No QTY DESCRIPTION BUFFER FITTMENT 6151128 17 NUT FLANGE M6 3162
13/06/06 Page 3 of 13 3782863 USE PART No QTY DESCRIPTION CAP WING COVER FITTMENT 6151267 6 CLIP CHRISTM
13/06/06 Page 4 of 13 3782863 ASSEMBLY SEQUENCE. 1. 1. Position the lower buffer on the winch bumper and assemble using the M6 flange nuts. 2. 1.
13/06/06 Page 5 of 13 3782863 6. 1. Push the top chrome tube through the hole in the buffer and fasten using the M12 x 40mm bolts, washers and spri
13/06/06 Page 6 of 13 3782863 9. 1. Using a 12mm drill bit, drill through the two slot holes at the front into the chassis cross member. 10. 1. F
13/06/06 Page 7 of 13 3782863 12. 1. Using a 13mm drill bit, drill through the hole in the main bracket and into the chassis rail. 13. 1. The mou
13/06/06 Page 8 of 13 3782863 15. Note: The washer bottle on the drivers side must be removed to gain access to the top bolt. 1. Tighten all bolts
13/06/06 Page 9 of 13 3782863 18. 1. To place the winch motor in the correct location the winch motor must be rotated 90 degrees, in a clockwise d
Kommentare zu diesen Handbüchern