Arb 3438320 Bedienungsanleitung PDF herunterladen (Seite 2)

Last Rev Date: 17/11/2009 Page 2 of 18 Fitting instructions# 3787059

GENERAL CARE AND MAINTENANCE

By choosing an ARB Bar, you have bought a product that is one of the most sought after 4WD products

in the world. Your bar is a properly engineered, reliable, quality accessory that represents excellent

value. To keep your bar in original condition it is important to care and maintain it following these

recommendations:

 Prior to exposure to the weather your bar should be treated to a Canuba based polish on all exposed

surfaces. It is recommended that this is performed on a six monthly basis or following exposure to

salt, mud, sand or other contaminants.

 As part of any Pre Trip Preparation, or on an annual basis, it is recommended that a thorough visual

inspection of the bar is carried out, making sure that all bolts and other components are torqued to

the correct specification. Also check that all wiring sheaths, connectors, and fittings are free of

damage. Replace any components as necessary. This service can be performed by your local

authorized ARB Stockist.

FITTING REQUIREMENTS

REQUIRED TOOLS FOR FITMENT OF PRODUCT:

METRIC SOCKET SET METRIC RING AND OPEN ENDED SPANNER SET

ELECTRIC DRILL 3 & 10mm DRILL BITS

SHARP KNIFE PHILLIPS AND FLAT SCREW DRIVER SET

FELT TIP PEN HACKSAW BLADE OR SMALL HAND SAW

FINE FILE OR SAND PAPER ELECTRIC JIG SAW

METRIC TAPE MEASURE ROLLS OF 25 mm & 50 mm WIDE MASKING TAPE

HAVE AVAILABLE THESE SAFETY ITEMS WHEN FITTING PRODUCT:

Protective eyewear

Hearing protection

NOTE: ‘WARNING’ notes in the fitting procedure relate to OHS situations, where to avoid a

potentially hazardous situation it is suggested that protective safety gear be worn or a safe work

procedure be employed. If these notes and warnings are not heeded, injury may result.

FASTENER TORQUE SETTINGS:

SIZE Torque Nm Torque lbft

M6 9Nm 7lbft

M8 22Nm 16lbft

M10 44Nm 32lbft

M12 77Nm 57lbft

NOTE:

♦ OPTIONAL FOG LAMPS TO SUIT THIS PRODUCT ARE P#6821201.

IF LOOM AND SWITCH

REQUIRED USE P#MD02 LOOM KIT, P#180209 SWITCH AND P#180215 SWITCH CAP FOR FOGS

♦ UP TO 900 SERIES ROUND OR 800 RECTANGULAR DRIVING OR FOG LAMPS SUIT THIS PRODUCT

1 2 3 4 5 6 7 ... 17 18

Keine Kommentare

Arb 3438320 Bedienungsanleitung Seite 2