Arb 3438260 Bedienungsanleitung PDF herunterladen (Seite 11)

Last Rev Date: 26/6/2009 Page 11 of 18 Fitting instructions# 3787027

BULL BAR PREPARATION

40. Fit the buffers to either side of the bull bar

using 6 x M6 flange nuts. Do not over

tighten.

41. Fit M6 cage nuts to four holes in lower pan

flange. The nut bodies are inside the bull

bar

IF NOT FITTING A WINCH

42. Apply rubber mould to edge of winch

hole cover panel and trim off excess.

43. Fit panel to top face on bull bar using 2 x M6

dome head stainless steel screws, flange

nuts and flat washers.

NOTE: The flat washers are to be sandwiched

between panel and top face of bull bar to stop

the panel pulling down to form depression

around screw heads.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17 18

Keine Kommentare

Arb 3438260 Bedienungsanleitung Seite 11