Arb 3436030 Bedienungsanleitung PDF herunterladen (Seite 8)

13/12/05 Page 8 of 12 3783101

10. IMPORTANT: For 2005ON vehicles, the

lower grille and rear support frame must be

trimmed for clearance to winch. Cut the

grille as marked, 450mm wide x 50mm

high, and notch 540mm x 25mm high.

Note: Cutting specified should clear most

winches, when putting bull bar in position in

step 17, check that adequate clearance has

been achieved, if not trim more from grille.

11. Cut out the corresponding lower center

section of the grille and headlamp support

frame at 450mm wide.

Once the trimming is complete, fix

reinforcing brace in place with self drilling

screws supplied. Fit the angle bracket to

fix the vertical strut in place as shown.

Fitting with winch

Fitting without winch

12. Fitting number plate – with winch

Peel off one side of the double-sided tape

and adhere to the top rear side of the

number plate. Note: Clean the adhering

surfaces before applying tape with an

alcohol solvent.

Peel off the other side of the tape and bolt

to the winch bumper with the M6 X 16mm

bolts and M6 flange nuts through the lower

holes of the number plate.

Press firmly to the top of the number plate

so the tape can properly adhere.

If not fitting winch.

Bolt the number plate through the top

holes using M6 X 16mm bolts and M6

flange nuts.

If desired the double sided tape can be

used down the sides of the number plate.

1 2 3 4 5 6 7 8 9 10 11 12

Kommentare zu diesen Handbüchern

Keine Kommentare