Arb RD81 Bedienungsanleitung PDF herunterladen (Seite 31)

6 Mounting & Connecting the Electrical System

6.1

Mounting the Actuator Switch(es)

Air Locker actuator switch(es) can be easily panel mounted inside the

vehicle in a 21mm x 36.5mm [0.83” x 1.44”] rectangular cutout.

NOTE : Only attach the cover plate to the face of the switch once

the switch has been mounted and wired correctly as the

cover plates are designed to be difficult to remove.

For reasons of safety and for ease of operation, the Air Locker actuator

switch(es) should be mounted in a location picked to best suit the

operator. Make sure you have taken the following points into

consideration:

 Switch(es) MUST be mounted and should never be allowed to simply

dangle from the wiring loom during vehicle use.

 Switch(es) should be within easy reach of the driver. Ideally, any Air

Locker switch should be able to be operated without physical effort or

distraction to the driver. Switch(es) should be mounted within the line

of sight of the driver so that switch position (‘ON’ or ‘OFF’) can be

visually determined by the rocker position and the illumination state.

 The position of the switch(es) should best eliminate any possibility of

accidental operation by the driver or one of the passengers.

 Switch cutout position(s) must be located in an area with a minimum

of 50mm [2”] of clearance behind the face of the cutout

 Switch(es) should not be mounted where they will be exposed to

water (e.g., in the lower section of an inner door panel).

 ARB recommends that you apply the Air Locker warning sticker

(ARB part # 210101) within close visual proximity of the switch

location.

Figure 18.

NOTE :

If no adequate position

can be found on existing

dashboard panels, a

surface mounted bracket

(Fig. 18.) may be

purchased from your ARB

Air Locker distributor to

suit 1, 2, or 3 switches.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 39 40

Keine Kommentare

Arb RD81 Bedienungsanleitung Seite 31