Arb RD05 Bedienungsanleitung PDF herunterladen (Seite 7)

2 Removing the Existing Differential

2.1

Vehicle Support

 Safely secure the vehicle on a hoist. We recommend supporting the

vehicle on a chassis hoist to keep the differential area at a

convenient working height and to leave the wheels and axles free

to be rotated and removed.

 Once supported off the ground, release the parking brake and

leave the vehicle in neutral. Chock the wheels if necessary.

2.2

Differential Fluid Drain

 Clean around the differential drain plug to prevent dirt from entering

the differential.

 Position a fluid drain reservoir under the differential and loosen the

differential drain plug.

 Completely drain all differential fluid.

HINT : This is a good time to check for metal particles in

your oil and in the bottom of the housing which may

indicate a worn bearing or differential component.

2.3

Removal of the Axles and Differential

 Remove the axles according to your vehicle’s service manual.

HINT : When removing the axles try not to damage the paper

gaskets behind the axle flanges.

 Disconnect the drive shaft from the flange of the differential.

 Remove the third member from the differential housing. Refer to

your vehicle’s service manual.

IMPORTANT :

Collision damage or heavy off-road use of your vehicle in the past may

have resulted in some degree of bending in the axle. Any misalignment

of the axle tubes may result in excessive wear and/or failure of your

differential and axle shafts. ARB strongly recommends that you have

your axle assembly inspected for concentricity and straightness before

installing your Air Locker.

1 2 3 4 5 6 7 8 9 10 11 12 ... 37 38

Keine Kommentare

Arb RD05 Bedienungsanleitung Seite 7