13/12/05 Page 1 of 12 3783101 If you have any queries regarding the installation of this product please contact the distributor from whom it was pu
13/12/05 Page 10 of 12 3783101 16. On the vehicle, remove the rubber air guide on the lower cross member area and discard. IMPORTANT :- When fit
13/12/05 Page 11 of 12 3783101 19. Tie the power steering lines to the chassis away from sharp edges and moving parts with cable ties provided. B
13/12/05 Page 12 of 12 3783101 If fitting with winch 21. With the winch cable through the roller fair lead. Mount the hook to the end of the cabl
13/12/05 Page 2 of 12 3783101 USE PART No QTY DESCRIPTION MOUNT BRACKETS TO VEHICLE 3756655L 1 BRACKET BAR MOUNT LHS
13/12/05 Page 3 of 12 3783101 BAR TO MOUNT ASSEMBLY 6151255 6 BOLT M12 X 40mm 4581050 6 WASHER SPRING M12 4581049 12 WASHER FLAT M12
13/12/05 Page 4 of 12 3783101 ASSEMBLY SEQUENCE FOR WINCH BUMPER. 1. Fitting mounting brackets Remove the bumper and two recovery hooks. Fit M1
13/12/05 Page 5 of 12 3783101 4. With the bull bar mounting brackets now in place (but not tightened) bolt the tension strap to the chassis usi
13/12/05 Page 6 of 12 3783101 Rotate motor end 180°. Undo the 2 x bolts securing the motor in position, withdraw bolts and rotate motor 180°, so t
13/12/05 Page 7 of 12 3783101 • For 16500lb winches, apply Sikaflex (or similar product) to rear of control box trim plate from fitting kit (not
13/12/05 Page 8 of 12 3783101 10. IMPORTANT: For 2005ON vehicles, the lower grille and rear support frame must be trimmed for clearance to winch.
13/12/05 Page 9 of 12 3783101 If not fitting winch cont. 13. Wrap rubber extrusion around winch cover. Place washers over the winch cover fixing
Kommentare zu diesen Handbüchern